Enable Saved Position

In the menu, “AUTO SELECT POS.” or “Auto select position” loads a previously Saved Position.
Further information about Saved Position is found here: Saved Position

With Saved Position activated, the Base Station remembers this type of Position Mode the next time it is turned ON. If working only with Saved Positions it is therefore not needed to select "AUTO SELECT POS." everytime the Base Station is turned ON.

Please note

• Using “AUTO SELECT POS.” requires a previously saved position.
• Using “AUTO SELECT POS.” requires that the Base Station is positioned at the exact same location where the position was saved.
• It is not possible to load a Saved Position from a different geographical location.

How To Enable Saved Position

1. From the Home Screen, press-hold on the push button to open the menu.

2. Navigate to “AUTO SELECT POS.” by single pressing the push button and press-hold to choose.
The display will now return to the Home Screen. Having selected "AUTO SELECT POS." the display will return to the Home Screen.

After choosing "AUTO SELECT POS." the screen will after a short while show:

Followed by returning to the Home Screen:

A position is now succesfully loaded and the Base Station is ready to use in Saved Position mode.

Please note

If the position is succesfully loaded saved the Base Station will go into “Saved Position” mode.

How to check the active Position Mode is described here:
Check Position Mode

Important

If the Saved Position is NOT succesfully loaded the display will show:

Reasons for showing ERROR NOT FOUND:

• No position is saved at current location.

If the display shows "ERROR NOT FOUND" the Base Station will go into "Single Use" mode.
If painting is continued it will not be possible to correctly overmark an existing field.